Subscribe to Newsletter
Subspecialties Glaucoma

When MIGS Goes Awry

sponsored by Optotek Medical

The last five years has seen the rise of MIGS – in terms of the “micro invasive” approach, and the devices that go with them. The information that’s currently out there (and there’s little beyond manufacturer-sponsored studies at the moment) suggests that, relative to interventions like trabeculectomy or tube shunts and valves, it’s a relatively safe approach to moderately lower IOP. MIGS, however, is not a panacea. There are other options, such as selective laser trabeculotomy (SLT), to control a patient’s IOP that are often worth pursuing first, and it’s definitely worth bearing in mind that the MIGS umbrella encompasses many unique devices, with unique implantation techniques, unique learning curves – and also unique issues.

Every ophthalmology department has a laser – and it’s more useful than you might think. I want to tell you about how I use YAG and Argon lasers to fix some of the issues that can arise with MIGS devices – and how this can be achieved in the clinic, rather than requiring a return to the operating theater for surgical stent revision.

Optimizing outcomes

There can be a big difference between what you can visualize with pre-operative gonioscopy at the slit lamp and what you can see through a gonio lens during surgery. First, patients can be more mobile on the operating table due to anxiety. Second, and most importantly, it’s about optics and lighting. It’s easy to get an adequate gonio view at the slit lamp and clearly define the corneal light wedge and Schlemm’s canal. Intraoperative microscopy is always coaxial, meaning you can’t illuminate obliquely, which makes it harder to identify exactly where you want to place the stent. Normally or heavily pigmented angle structures might be adequately visible under these conditions – but this isn’t the case with very pale angle structures. When I come across this during slit lamp gonioscopy, I use an Argon laser to “mark” the meshwork in the nasal quadrant (in three areas usually) meaning I just have to insert my stent on the mark during surgery. Anecdotally, because the region has also been photocoagulated by the laser, it also reduces the hemorrhage that sometimes occurs as the sharp tip of iStent enters the angle.

Figure 1. iStent: an illustration of a perfect insertion (above).

Figure 1. However, if the angle of the stent’s lumen points down toward the iris (above left), rather than being perpendicular or upwards toward cornea, this can be a problem. If the lumen points below this plane (red dotted line in (top)) or if the angle is cramped, then there’s an increased risk of the iris “surfing” into stent lumen when the flow of aqueous is higher. YAG laser energy can be used to unblock the iStent and ablate some of the iris to stop it from becoming blocked again (above right).

Figure 2. A poorly positioned Xen stent (above left) where the flat tip has been blocked, and post-YAG laser treatment (above right) – still flat to the iris, but the tip has been cleared, and an “iridoplasty crater” has been created to prevent further blockage.

Treatment complications

Anything with a lumen in the eye can get blocked, and MIGS devices are no exception. Be it blood, fibrous or inflammatory membrane – or even iris tissue – it’s important to note that, rather than performing revision surgery, you can use a few shots of a YAG laser to clear the blockages. There are a number of risk factors for stent blockage – and a lot of it comes down to ocular anatomy. Let’s take the iStent (Glaukos) as an example (Figure 1). If you’re placing an iStent into an eye that’s slightly shallow or the angle is not wide open, the iris is, by definition, quite close to the stent. If your patient’s iris is a bit high, or for some reason, someone’s dilated the pupil, the pupil can plug the lumen of the stent. The iStent lumen can rotate anteriorly or posteriorly whilst still perfectly seated in the canal. If you leave the stent pointing to the cornea it should never block. However, leaving the lumen pointing below the iris plane (or if your stent rotates) results in an increased risk of problems. These risks increase in shallow eyes and eyes with narrow angles – there’s simply less margin for error. A recent review of the iStent literature (1) found that the rates of occurrence of malpositioning and occlusion that necessitated surgical intervention (YAG laser, tissue plasminogen activator [tPA], or stent revision) ranged from 4.5–11.3 percent – and was cited as the most common complication across the studies. But irrespective of whether the iStent has become malpositioned and blocked because of anatomy, poor surgical technique, postoperative movement or plain bad luck, it can be fixed with the YAG laser in just a few shots – in the clinic, rather than the operating theater. After all, prevention is better than cure.

Optotek Medical Milestones

1991 Optotek founded
1996 R&D and production of optoelectronic products
1997 First laser systems for dermatology produced
1999 First ophthalmic laser systems 
1999 OEM YAG laser system and Q-Las photodisruptor launched
2004 HawkEye portable slit lamp launched
2007 Acquired by OptoPol technologies
2008 LacriMax, OptoYag, OptoSLT, OptoYAG&SLT launched
2009 OptoPol technologies acquired by Canon Inc.
2014 OEM YAG laser system and OEM combined laser system launched
2015 New LacriMax launched
2016 OptoSLT nano launched – the first DPSS laser for SLT

So once again, the approaches I take to fix these situations are: 

  • Clear any blockage – I use my Optotek YAG laser to quickly clear the stent, and
  • If the iris is being chafed or snagged, I use an Argon laser to contract the iris out of the way (behind the stent), so there’s no longer any contact.

The use of the YAG laser to unblock stents isn’t limited to iStent and Xen – the “intracanalicular scaffold” Hydrus (Ivantis) stent has an inlet and three fenestrations that can also be subject to blockage, and can be opened with the YAG laser too.

Glaucoma surgeons are familiar and comfortable with using lasers to lower IOP – and, as you can see, they can serve a double purpose with MIGS stents, and help avoid revision surgery in some cases of blockage or malpositioning. As increasing numbers of cataract surgeons are implanting MIGS devices as part of their offerings, I feel it’s important they’re aware of the utility of these lasers and what they can do.

Dan Lindfield is a consultant ophthalmic surgeon at Optegra, and glaucoma lead at Royal Surrey County Hospital, England, UK, and reports receiving honoraria and travel support from Allergan applicable to Xen.

Receive content, products, events as well as relevant industry updates from The Ophthalmologist and its sponsors.

When you click “Subscribe” we will email you a link, which you must click to verify the email address above and activate your subscription. If you do not receive this email, please contact us at [email protected].
If you wish to unsubscribe, you can update your preferences at any point.

  1. SR Wellik, EA Dale, “A review of the iStent(®) trabecular micro-bypass stent: safety and efficacy”, Clin Ophthalmol, 9, 677–684 (2017). PMID: 25931808.
Related Case Studies
Business & Profession Glaucoma
TrabEx Pro: The Next Level in MIGS

| Contributed by MST

Finding Ocular Surface Inflammation

| Contributed by Quidel

Product Profiles

Access our product directory to see the latest products and services from our industry partners

Here
Register to The Ophthalmologist

Register to access our FREE online portfolio, request the magazine in print and manage your preferences.

You will benefit from:
  • Unlimited access to ALL articles
  • News, interviews & opinions from leading industry experts
  • Receive print (and PDF) copies of The Ophthalmologist magazine

Register

Disclaimer

The Ophthalmologist website is intended solely for the eyes of healthcare professionals. Please confirm below: